Posted: Wed Jan 04, 2006 3:55 am Post subject: [Asterisk-Users] Re: Start recording after call started
In Asterisk v1.2.1 check the "featuremap" section of the "features.conf"
file. You also need to add the "w" or "W" option to your "Dial" cmd where
appropriate. So with the feature mapping below pressing *1 would start
recording.
[featuremap]
blindxfer => #1 ; Blind transfer, default is #
disconnect => *0 ; Disconnect
automon => *1 ; One Touch Record
atxfer => *2 ; Attended transfer
----- Original Message -----
From: "Technical Support" <support@ocg.ca>
Newsgroups: gmane.comp.telephony.pbx.asterisk.user
Sent: Tuesday, January 03, 2006 7:54 PM
Subject: Start recording after call started
Quote:
Is there a way to tell asterisk to start recording DURING a call?
Can I flash, then *XX, and then flash back to my call while asterisk
records?
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
In Asterisk v1.2.1 check the "featuremap" section of the "features.conf"
file. You also need to add the "w" or "W" option to your "Dial" cmd where
appropriate. So with the feature mapping below pressing *1 would start
recording.
[featuremap]
blindxfer => #1 ; Blind transfer, default is #
disconnect => *0 ; Disconnect
automon => *1 ; One Touch Record
atxfer => *2 ; Attended transfer
I need to dail *1 to quickly. Can that be changed?
Posted: Wed Jan 04, 2006 3:37 pm Post subject: [Asterisk-Users] Re: Start recording after call started
On Wed, January 4, 2006 15:45, Tomislav Parcina said:
Quote:
In article <003b01c610e2$b7596420$6400a8c0@bluejay>,
LJ.Shields@Verizon.net says...
> In Asterisk v1.2.1 check the "featuremap" section of the "features.conf"
> file. You also need to add the "w" or "W" option to your "Dial" cmd
> where
> appropriate. So with the feature mapping below pressing *1 would start
> recording.
>
> [featuremap]
> blindxfer => #1 ; Blind transfer, default is #
> disconnect => *0 ; Disconnect
> automon => *1 ; One Touch Record
> atxfer => *2 ; Attended transfer
I need to dail *1 to quickly. Can that be changed?
Try experimenting with this:
[general]
featuredigittimeout = 1000 ; Max time (ms) between digits for
; feature activation. Default is 500
HTH!
--
F Peeters
PIII 450 - 1 GB - * 1.2 - BRIstuff 0.3.0 Pre 1 - Florz patch
2 Sweex HFC-PCI modes=2 sync_slave=2 timer_card=0
Cologne HFC-S pins #52, #54, #55 connected in parallel for synching.
AMD Duron 1GHz - 1GB - * 1.2.1
2 Sweex HFC-PCI cards
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum