Posted: Sun Mar 15, 2009 7:55 pm Post subject: [Asterisk-bsd] Passing opemode parameter to zaptel drivers
Hi all,
I'd like to set the opermode in wcfxs/wcfxo zaptel kernel modules to
meet regional pstn requirements.
I'm using zaptel-bsd-1.4.6 on freeBSD 6.3 and an Openvox A400P pci card.
Also seen/read
http://lists.digium.com/pipermail/asterisk-bsd/2005-October/thread.html#1251
then tried using hint.wcfxs.0.flags="1" in /boot/device.hints but no
luck. Tried also to set flags in loader.conf but, again, nothing worked
and this setting was simply ignored without any error in system messages.
Someone know the right way to address this problem in freeBSD?
_______________________________________________
--Bandwidth and Colocation Provided by http://www.api-digital.com--
Posted: Sun Mar 15, 2009 7:56 pm Post subject: [Asterisk-bsd] Passing opemode parameter to zaptel drivers
Hi all,
I'd like to set the opermode in wcfxs/wcfxo zaptel kernel modules to
meet regional pstn requirements.
I'm using zaptel-bsd-1.4.6 on freeBSD 6.3 and an Openvox A400P pci card.
Also seen this thread
http://lists.digium.com/pipermail/asterisk-bsd/2005-October/thread.html#1251
then tried using hint.wcfxs.0.flags="1" in /boot/device.hints but no
luck. Tried also to set flags in loader.conf but, again, nothing worked
and this setting was simply ignored without any error in system messages.
Someone know the right way to address this problem in freeBSD?
_______________________________________________
--Bandwidth and Colocation Provided by http://www.api-digital.com--
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
