Posted: Fri Apr 17, 2009 12:44 pm Post subject: [asterisk-users] 2BCT last mile... Hopefully
Ok, so I’ve made progress on 2BCT (2 B-Channel Transfer). I’m assuming that the debug info below shows that XO doesn’t have 2BCT enabled on my line, but if anybody can confirm that’ll let me be way more indignant. J
Posted: Thu Apr 23, 2009 4:20 pm Post subject: [asterisk-users] 2BCT last mile... Hopefully
Max Metral wrote:
Quote:
Ok, so I’ve made progress on 2BCT (2 B-Channel Transfer). I’m assuming
that the debug info below shows that XO doesn’t have 2BCT enabled on my
line, but if anybody can confirm that’ll let me be way more indignant. J
It would appear that the switch doesn't like what you're sending it.
That means either your switch at the other end is not configured with
this feature enabled or that your switchtype is set incorrectly for the
actual switch type that the other end is expecting.
From the message you are sending to the other side, it would appear
that you are configured for either 5ESS or national switch type.
Another possiblity (although low in probability) is that it doesn't like
being sent the transfer message so soon, since it would appear that we
have not yet received the CONNECT-ACK from the other switch by the time
we send the transfer request.
You could try inserting a Wait(5) after you Answer() the call in your
dialplan before Dial()'ing back out to verify that the call is
completely setup. Make sure you try explicitly Answer()'ing the call
first in your dialplan before Wait()'ing or Dial()'ing back out, at
least until you figure out what the problem is.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum